![vcds no response from controller vcds no response from controller](https://www.ross-tech.com/vcds/tour/screenshots/mainscreen01.png)
I then tried the Security Access and I was prompted with "Controller refused to send a seed! Error 7F: Service not supported in active session".įortunately I do not NEED to do a Static Regen as my soot content is at 16grams as this info does display, but going forward it would be nice to know I have full access on the software. Alguma sugestão dos colegas eu estou iniciando na pratica deste scanner. É uma interface 11.8 e está instalado no Windows seven. I also get the same error when attempting to access other procedures within the Engine Control Module too, not just the DPF Regen. Olá hoje fui testar um cabo do vcds e acessou o veículo só que quando entro no bloco de leituras após alguns segundos ele mostra a mensagem ' no response from controller'. However, when I go to run a DPF Forced regen I get an error message "ERROR: Services not supported in active session".
![vcds no response from controller vcds no response from controller](https://i.ytimg.com/vi/YGP_XsaHiv0/maxresdefault.jpg)
The van (T6 2017) connects fine and I am able to read / clear faults. With all of my vehicles I like to have control over the diagnostics and decided to purchase a cable, 062 is if Control Module Version is > 0800, else 067. 062/067 - Clutch Adaptation, those numbers did not change. So I went to the VAG COM setup chose COM3 and confirm it identifies the cable. In VagCom setup COM3 reported as seeing the cable succesfully but like you got no response when connected to the car. I've been on the Forum for a few weeks now whilst toying with the idea of buying a T6. 065 (Clutch pressure), all showed 0.00 PSI running or not, so do not know if/how reset. I had this problem with an Ebay cable and VCDS lite (and VAGCom 409) - here's how I fixed it.